February 3-10, 2020
Looking for a lower cost option for SDS Training? This open enrollment training is priced per student and is a cost effective alternative to our group training offerings that cover the same material.
There are still spaces available for SDS Remote Physical Training so hurry and book your spot today!
Course cost, descriptions and requirements are below. If you would like to enroll for this course or have any questions, please contact Jared Yates at firstname.lastname@example.org
Course Cost: $1,495 USD per student+$395 for SDS Physical Design eLearning Schedule
February 3-6 (4-hour sessions each day)
February 10-13 (4-hour sessions each day)
Remote instructor-led web environment consisting of up to 32 hours of training for one (1) attendee. Course participation will be limited to no more than eight (8) students. Training will be provided in daily 4-hour web training sessions over a two-week period. The training covers the topics below:
Remote Web Training Sessions 1-4:
Basic Inventor Topics as required for SDS Physical Design Training
Remote Web Training Sessions 5-8:
Strategic Modeling and Working with Large Assemblies
Remote Web Training Sessions 9-12:
Introduction to Substation Design Suite™ Physical Design, Above Grade Tools (Cable runs, Bus runs, Lightning Protection) and Below Grade Tools (Grounding, Trenching, Conduit)
Remote Web Training Sessions 13-16:
Advanced Substation Design Suite™ Physical Design, Substation Design Content Editor, Design Checks and Substation Output
Each student is required to purchase eLearning training material.
A minimum of four (4) students are required to conduct this course. If the minimum required attendees are not met two (2) weeks prior to the course start date the course will be canceled and the customer or registered attendee will be notified.
Autodesk Inventor or Inventor Professional Software and the Substation Design Suite™ Physical Design plug-in.
The SDS Physical Design plug-in requires the same hardware specifications as Autodesk Inventor. Autodesk Inventor hardware specifications are shown at the following webpage:
In addition to the list above, 32 GB of RAM (memory) and a Solid-State disk drive is recommended.